Engine Comm Failure Message
Posted: Mon Feb 12, 2024 1:19 pm
I have a 2009 safari Cheeteh with a Cat C9 ACERT motor. Last year soon after I started it up the ILB displayed an 'Engine Comm failure Message" and the coach went into limp home mode where it would not go over 15 MPH. Since then, I have had a mobile diesel mechanic scan the coach for errors and have had it towed to Rush Truck Centers and later towed back home. Both mechanics said that there was a generic CAN Bus communication error and that the engine and transmission in the coach are ok. They both said they believed that the problem was with the Safari provided CAN Bus network and electronics and refused to do any further troubleshooting. I removed the ILB display from the dash and sent it to Medallion Instruments for bench testing. It failed bench testing and I ordered and installed a new ILB at a cost of over $2000. This did not cure the problem. Recently, I cleaned and checked the ECM fuses and connections and the J1939 CAN Bus ground connection to the frame. I also checked and cleaned most of the gray plastic connectors in the J1930 CAN Bus backbone cable with the exception of the one that connects to the TCM (Because I cannot find if under the coach). None of these actions has cleared the "Engine Comm Failure" message. Any help or troubleshooting advice is greatly appreciated.