Page 1 of 1

Door Seal

Posted: Thu Jul 09, 2020 7:38 am
by glenn robbins
I have a 1997 Safari Serengeti Ivory 37 ft. Has any one replaced the door trim seal on the entrance door, and if do you know where I can buy the rubber seal or the part numbers when ordered. The seal has decade after all these years and is now leaking

Re: Door Seal

Posted: Tue Jul 26, 2022 8:18 am
by Zanzibar Bill

Re: Door Seal

Posted: Sat Aug 06, 2022 3:11 pm
by astrnmrtom
Yep, just did mine a couple days ago as well as replacing the broken Pos-a-lock hold open mechanism. The link in the previous reply is the place to use. The price is per foot. You'll need to measure your door at the appropriate points. You'll want to get some new spline material too. One thing to note is the best way to replace the trim is to remove the door leaving the hinge connected to the doorframe, not the door. The door is HEAVY! I did it without removing the door but it was tedious because there isn't much room for pushing the seal and spline back in place on the hinge side. Because the hinge is made up of multiple pieces, I worked my way along the inner edge by removing a couple sections of hinge, inserting the spline, reattaching the hinge and repeating. This also maintains door alignment. The hardest part was feeding the new seal into the groove on the hinge side. Once started you work along the seal pushing it into the groove. The job wasn't hard, I just needed to take my time.

Re: Door Seal

Posted: Sat Aug 06, 2022 10:09 pm
by astrnmrtom
Here's the number for the door seal: Kit number K007-757
Follow the instructions on the kit page to measure your door.