'Note: I fat fingered Al’s email address on my initial reply. So if you intend to use a ‘reply all’ note his original email to get his correct address. R/wm
Sent from my iPhone
On Aug 7, 2019, at 7:27 AM, bilmac36 wrote:
Al,I think I cracked this code for my coach. Here is a pix of them, and it is Napa p/n 380501 for rear going from tee to caliper. Believe the male end going into caliper are 7/16” -24 pitch.Most on here will say go have them made, but in my location, central MS, all shops throw out the ‘liability’ word and will not make them.
Ok, just reread your original email, these may not be same for you as you note one end is female flare. So here is what I did to finally find mine. I went and sat with a Napa parts counter rep and we went through the brake hose pix book and found the correct male & female ends I needed for mine on the front. I found the rear one by searching several large truck models of +/- same year on Rock Auto. Then took that p/n to Napa. Rear:[img]cid:274ADC14-8401-4950-BD66-792263E7FB34[/img]
My front ones are Napa 38911.
Also, Joe Peel, from SF group recommended
https://brake-hose.com for making the hoses and said ‘great service.’ Good luck in your search,Willie, Connie is ‘95 Continental, 8.3L, Ally 6spd
Sent from my iPhone
On Aug 6, 2019, at 10:16 PM, Al Glick aglicknmex@... [Safarifriends] wrote:
Not having any luck finding the rubber lines for front callipers or the rubber hose to the rear axle
All connections are male and female flare
Nothing in Ford F600 any year seems to fit .
Any help appreciated !! Thanks in advance.
Al
'