Lithium Battery Isolation Manager 225
-
- Posts: 7
- Joined: Sun Feb 04, 2024 4:01 pm
Lithium Battery Isolation Manager 225
Has anyone installed the Lithium battery manager? If so could you help with the wiring layout. I am converting to 4 lithium batteries. Thanks
Re: Lithium Battery Isolation Manager 225
I just bought one, along with a battery and solar panels/charge controller kit. I’m planning to install it the week after next. I’ll let you know how it goes. In the meantime, I found this video helpful. His installation is on a Beaver, but he provides great explanation. https://youtu.be/-3sHpgQK2R4?si=C-ObMK8IWB6Va4o8
-
- Posts: 7
- Joined: Sun Feb 04, 2024 4:01 pm
Re: Lithium Battery Isolation Manager 225
Thanks for the information. I have ordered the batteries and the Manager. I am trying to decode all the wires and what looks like fuses on the fire of my 1997 Safari.” It’s a spaghetti run”
Re: Lithium Battery Isolation Manager 225
Thank you for sharing that, it may be helpful for me as well. It's nice that your current diode BIM is so close to the solenoid. Your setup is much closer to the AZ Expert video that I shared than that of my Safari Trek. My isolator is mounted above the engine, the coach batteries are under the stairs on the passenger side, the power switch and inverter are on the driver side under the galley, and I haven't tracked down yet the chassis battery. I'm assuming next to the engine. I'm installing 800w of solar as part of my battery upgrade, so I'm hoping to run the power along the same path as the original 25w panel that was on the roof. It's going to be a busy week.
-
- Posts: 7
- Joined: Sun Feb 04, 2024 4:01 pm
Re: Lithium Battery Isolation Manager 225
Good luck with the solar installation. Working with these older machines is a learning curb.